Peel off the adhesive and fix it to the sensor.Clean the area where you'll install the sensor.To mount the detector using the adhesive: You can install the detector using either the adhesive tape or the mounting bracket included in your kit. This will keep it out of the way of kids, pets, and other things that might dislodge it. You should install the Ring Motion Detector on a wall or in a corner about seven feet high. When no motion is detected for four minutes, the sensor returns to normal. If something walks in front of the motion detectors lens, it will become faulted. The Ring Motion Detector watches for motion in an area. Motion Sensors: Frequently Asked Questions Battery Level: If an Alarm device reports battery levels, the battery status will be shown in the top right.This varies by Alarm device, but usually indicates that the cover is off or that someone has been tinkering with the device. If the system is armed and the Alarm device is being monitored, this will trigger the alarm. A door or window has been opened and triggered a sensor or a motion detector has detected motion. This means that an Alarm device has been tripped. For contact sensors, they're currently shut and lined up properly. For motion detectors, they're not detecting any motion. When an Alarm device is "cleared" it means that the device is working fine and is in its default state. Device State: The current state of the Alarm device is shown in the bar at the top of the page and the icon at the top left corner of the device icon or image.Take note of the current state of the device along with its battery level: If you need to know the status of a particular Alarm device, the device details page in your Ring app contains the current state, controls, history, and (if applicable) the battery level of a particular Alarm device. If you experience any issues removing an Alarm device, you should check the device manufacturer’s instructions to see if there’s anything else you need to do. The Base Station will attempt to remove the Alarm device from your system.Follow the instructions, then tap Remove Device.Tap Device Settings (gear icon) then Remove Device at the bottom of the screen. ![]() Tap the device that you want to remove.Select your Alarm or Alarm Pro Base Station under Security.Once you've added the Alarm device, you can rename it or change its category. Follow the remaining instructions to add the Alarm device.Your Base Station will start listening for a new nearby Alarm device. Review the additional instructions, then tap Add Device. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |